Interested to Buy Any Domain ? << Click Here >> for more details...
all 3 current transformers (C.T) are burnt in a L.T Panel -
what are the possible reasons
- 5 Answers
- 7119 Views
- I also Faced
- E-Mail Answers
Answer Posted / onlykk
The CT connection point of Energy meter/MDC which was connected in the system is opened.
Main cause CT points opened at any where.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calculate the heat load for a electrical room
how you configure motorvision relay (L&T make)from DCS
how does a shunt reactor maintains the bus voltage???
how to identify the cable quality and what is flame proof cable
What range of speed can you get with the field control method of speed control of d.c. Shunt motor?
why we use the 100% and 95% stator earth fault protection for the synchronus generator ?
In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?
why we setting 95 deg and 105 deg in wti and oti of distibution transformer ? give the reson for that ?
In what condition the HT fuse breakes?
How to calculate the External Resistance required for 60HP slipring motor in case no any data of the Motor is available???
Define what is difference between fuse and breaker?
Disadventage of cable-gland earthing if any ?
why 15 kw motor winding resistance is low then 5 kw motor winding resistance?
what is meant by LCR meter? where its useful ?
upto how many load can v connect to stabilizer which is used for tv
