Answer Posted / ghannesh
hi all we know all zebraic sum of the current meeting of the junction point is zero star point is 0 it is connected to earth( we are called neutral) for balancing per phases
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why should the primary of transformer be connected in delta in a heat run test?
Why we cant store an ac power. If we coo store in which device we can?
Can any one give an explanation about rating factors of cable? if we are laying the cable on the air with an temp 15 degree then rating factors will be 1.15 and if we are laying the cable on the air an temp 60 degree then rating factor will be 0.76 please describe it and what is the difference between rating factor and derating factor?
what size steel armoured cable is required to support 1500kva capacity. would 70mm squared be enough or would I need 90 or 120mm squared 3c plus earth
The screw thread commonly used for transmission of motion is one of the following types of threads
Briefly define and explain the following different types of Pulse Amplitude Modulation (PAM) with some examples. i) 2-PAM ii) 4-PAM iii) 8-PAM iv) 16-PAM v) Quadrature Amplitude Modulation (QAM)
Do any one know exacatly when the results for NHPC held on 8th march 09 for engineering trainees will be released ?. if so please post it, i'm eager to know it.
Why Water motor is not taking a load or pressure while everything is correct. (Note: Motor running properly)
Why are the laminations insulated from each other?
pls tell us AC plant are how do work and parts name with picture
How many types of faults are there in 3 phase power system?
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
What is an 86-P or an 86-A trip
why a tester wont shock while testing the power in house
what is the difference between neutral and earth