Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / morsli
instrumentation job is to calibrate transmitters for exemple level ,pressure ,flow we use multimeter for the analog transmitter ,in smart transmitters we use a hart protocol .
other work is to calibrate pressure switch ,level switsh,temperature switch .
you adjust the valves switches ,on and off ,open and close.
you calibrate the valve with positionner ,pneumatic positionner or digital .
you deasmantel the pneumatic control valve ,and change the spare parts,the calibrate without positionner ,the open top at 3 psi and the close top at 15 psi.
you look for ground when there is a problem in instrument wiring.
you adjust the controller parameters PROPORTIONAL -INTEGRAL and DEREVATIVE when the controller is operating ,on line process.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Sir, I want junior executive, Instrumentation question papaer for IOCL, Plz send to arabinda.ghosh83@gmail.com
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
What is force balance principle?
i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......
Q1]IF THE RANGE FOR FLOW IS -35 TO 125 WHAT WILL BE THE SPAN FOR ABSOLUTE AND FOR NORMAL? Q2]HOW TO CALIBRATE CAPILLARY TYPE LT? Q3]HOW MANY ERROR CALCULATIONS ARE THERE USED IN PROCESS INDUSTRIES? Q4]HOW TO CALIBRATE TEMPERATURE TRANSMITTER? Q5] HOW TO CALIBRATE LEVEL TROLL AND HOW TO CONNECT? Q6]PLEASE TELL ME THE BASIC FOR INSTRUMENTATION WHICH IS APPLIED FOR CALIBRATION AND FOR ALL? PLEASE MAIL THE ANSWER TO honest_yes@yahoo.in
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
How ejector(or)evactor air pump is working in thermal power plant?
Explain plc level and its type?
while i check zero check for dp flow transmitter some fluctuating came (0 to 458 kg/h) what is the reason?
Displace type LT to be calibrated in workshop, wt. 40, dia- 60 mm, density- 0.8kg/cm3.
What is super thermocoupal?
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
If a control valve is hunting means means if we are giving 50% to the cv, the cv will open at 51% then slowly slwoly it will reaches 49% , so what to do for solve this problem. The cv is double acting and mounted for anti surge operation, it having 4 nos. volume booster, one sov, one positioner, etc..?
sir, i preparing hpcl,ongc,barc,hal exams(instrumentation engg)pls send a placement papers
