What is the Specific gravity of Fine and Coarse aggregate ?
- 1 Answers
- 4791 Views
- Sohar Aluminium, I also Faced
- E-Mail Answers
Answer Posted / kiran lokhande
Specific Gravity of Fine aggregate is 2.70
and Specific Gravity of Course aggregate is 2.90
| Is This Answer Correct ? | 5 Yes | 5 No |
Post New Answer View All Answers
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
What are the problems one might face while having a Cantilever balcony?
What is the standard rate of installing ties for column(60cmx60cm) and beams(50x850)(weight)
what is Brest Wall?
What is the likely strength of a 1:2:4 concrete mix?
How to calculate brick work quantity?? Block work quantity??
What are the govt approvals required for starting of power project. means from initial site grading and excavation work.exm. blasting in hard rock, deep excavation, cut off trees from site.
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
2. In a container filled with each of the following materials, at a porosity of 40%, determine the upward gradient required to cause the quick condition (a) Lead shot with a G = 13.75; (b) Fibre beads with G = 2.15; (c) Sand with a G = 2.32
What is the average density of soil?
please what are the required bars for a beams of 6mx6m and 450x300mm, one is continuous and the the second is discontinuous ..Its a commercial building (church)
what is right & short method of measurement of slab&beam
What is the release of lien?
how to tie 10 legged stirrups
Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.
