Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between Split ring and slip ring?
- 8 Answers
- 37225 Views
- I also Faced
- E-Mail Answers
Answer Posted / rahul mohan
slip ring is used in AC MACHINES because they transmit electric power from stationary to rotating structure, and it does not change the current flow direction.
while, SPLIT rings are used in DC machines that changes the current flow for every half rotation and is used to convert ac to dc.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
what is the difference between directional & non directional earth fault with example please explain.
What is the difference between grid and off- grid system??
What are your personal skills and abilities for such a Master Course and your possible preparation to undertake this course?
Why mostly the HV side of transformer has Delta?
During regenerative breaking= A rotating magnetic field is reversed B slip is positive C torque is positive D slip is negative
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
How much ph is maintained of water resistance starter for slipring induction motor ?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
If Dg set load increase 25%, How much increase fuel Consumption (15 kva 2 cylinder DG set)
What will be the effect of circulating current in HT xlpe cable when both the armour ends are grounded. Will the termination fils after some time in case of 33 kv supply.
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
what are the advantages and disadvantages of oil filled cables over XLPE cables
in Contactor opearation Why there is a difference in the values of the operate and release voltage in case AC supply
What is given by the definition in BIL IMP/PF = 950/395 kV. This was found in a name plate of a power transformer.
When MICC cables used ?
