Interested to Buy Any Domain ? << Click Here >> for more details...
why in vortex flow transmitter dcs range is configuring less than sensor range. eg (sensor range 500-25000 kg/hr and dcs range 0-24000 kg/hr).
- 1 Answers
- 2909 Views
- Daelim, I also Faced
- E-Mail Answers
Answer Posted / mohamedhega
range must be the same in both transmitter and dcs ,to give accurate representation of flow
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
pls give me presant awerness quistion and answer in my emailid.
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
what is the input of digital counter during the the calibration time?
How d.p. Transmitter can be applied to close tank?
How can i copy program (parameter) from mm440 (V.F.D.) by using BOP?
Draw block digram for well head from well to shipping pump?
how to calibrate load cell
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
What is loop1 and loop2 in MTS LT?
can any send me a forbes marshall dtron 316 manual
Calibration procedure for water rotameters
How many interlocks at turbine side?
What are the uses of orifice plates?
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
How to measure the dust in chimney(spm)?
