Interested to Buy Any Domain ? << Click Here >> for more details...
why we use stones or rock pieces in transformer area?
- 10 Answers
- 30759 Views
- I also Faced
- E-Mail Answers
Answer Posted / puja
To prevent the snake's due to hissing noise generated by changing the dimension of core flux...
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
A jet of fluid strikes a plate What was the force required to counter it?
difference between semiconductor & conductor & insulator?
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
What are the classifications of heating element?
how to calculate the torque of a motor?
What is formula calculation size cable wire ?
i want to know about torque of slip ring induction motor
electromechanical relay type identification example : type=tjmh t-stants for j- m- h-
How to check the LM324 Ic
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
what is apparent poewr, reactive power, & active power?
What are the different types of LT Cables?
Distribution transformer we provided 2 separate earthing pit for Body and 2 separate earthing pit for neutral,we can not connect separate body earthing pit to other earthing pit but we do metal glanding in secondary side cable termination in both side, transformer and PCC panel (LT Panel), is this safe for transformer and other equipment?
