Answer Posted / anuraag bhairavabhatla
Hi guys this is Anuraag.
All the answers said above are not
Absolutely right.
OHM'S LAW :In any linear bilateral
Circuit under constant temperature
and pressure the current is directly
Proportional to voltage
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is the type of feedback used in an op- amp schmitt trigger?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
send me all basic electrical question and answers
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
what is the profesional board for electrical engineer what is thepast and during construction for electrical engineering
BRIEFLY EXPLAIN THE STORAGE CLASSES AND THEIR TYPES IN C
HOW TO TEST A LIGHTENING ARREST ER ?
one split ac how can told of this ac which Tr tell me us
how much LT load can bear by the 100 KW HT connection.
Draw torque - speed curve and load curve of induction motor? mark operating point ?
how to calculation increase power factor for single phase
orifice sizing how done, checking & selection
What is critical disruptive voltage?
How to calculate MCB Breaking capacity.
