Interested to Buy Any Domain ? << Click Here >> for more details...
give classification of transducer based on type of application
- 2 Answers
- 3560 Views
- I also Faced
- E-Mail Answers
Answer Posted / abhik sengupta
Two types.active and passive transducers
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
can any one tell me when ongc placement test and its forms is available????/ pls tell me if u know
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
please tell me what is a light up procedure of Cfbc boiler and what it's axuillaries of cfbc boiler?
how radio frequency level probes works with its controller ? what is its principle ? pls give me brief explanation?
what about your moleg in pogrees with company
what deference between panel earth and systemearth
what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
draw shematic diagram of c/v positioner(smart type)?
Differentiate between ultrasonic flowmeter and radar type flow meter
2. What is ultrasonic flowmeter?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
why would you like to join our company
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
