Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by "tampering detection" of a electrical
energy meter?
- 3 Answers
- 5414 Views
- I also Faced
- E-Mail Answers
Answer Posted / govind singh chouhan
The tampering detection in electrical meter is a function that log the tampering events when the tampering occurred.
means if you tamper the meter by applying the magnet then the meter is logged the magnet tamper with date and time and meter may start to register the energy on maximum load (240V and 60A).
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in dc suppy frequency is zero why? if dc frequency is zero how to exist dc transients and ac transients
Explain what is clipper and clamper circuits?
Pl. brief about break-down maintenance of machine tool.
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
what is the basic need of domestic loads 1- voltage 2- current
How to setting the volume of RTCC panel AVR (11kv) controller
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
What is the restart inhabit setting in ABB spam150c relay (Motor protection relay)
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
1))why we run three phase or three different circuit from a single conduit 2)) why not two circuit of different phase run in same conduit?? and why we run same three cicuit of same phae run in single conduit??
How do the synchronizing lamps indicate the correctness of phase sequence between existing and incoming alternators?
why ss stablity limit is more transient stablity limit?
A 230V dc shunt wound motor has an armature resistance of 0,15Ω.When operating on no load at 650 rev/min the armature current is 6A . The motor takes a full load current of 85A. Calculate the full load speed if the field flux is (i) maintained constant (ii)reduced by 0,03
