Answer Posted / amit saini
Neutral is used to compete the loop. And ground is used pass any leakege current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?
what is isloted barrier how it works and what are the main purpose.how it make safe area.
What are different types of valves?
Explain bernoulli’s theorem.
what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.
send me last 5 years questions asked in rrb chennai, for section engineer
Explain the combusion chamber
what is different between 2,3&4 wire rtd and how much maximum distance using plc to field.
1.can you use SCADA instead of DCS,DCS instead SCADA 2.Difference between DCS and PLC,can their role be reversed i.e. role interchange 3.Difference between RTU and PLC
principle of dead weight tester ?
Which is your favourite subject & explain any one topic of it.
what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?
Draw symbols of the following :
Explain signal isolator