why we use star and delta connection?why we donot give the
supply directly?
- 12 Answers
- 55245 Views
- Hitech, Siemens, Tata Steel Limited, I also Faced
- E-Mail Answers
Answer Posted / rupam dwivedi
reduse the starting current@starting torque
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the use for cable entry in control room?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
what is relation between ct and pt ratio with multiplication factor of a energy meter? is there any other factor on which multification factor depend?
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
What si the d/f b/w KVA & KWH, kvarh & kvar, kwh & kvar phase voltage & line voltage
why impudance relay used for medium transmission power system? why not others?
what is the excess air in furnace
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
explain supply side and demand side energy management with advantages & disadvantages
we have an energy meter in a capacitor bank panel, So should we consider it's readings as energy consumption on daily basis. (when capacitor bank doesn't have any energy losses)
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
Why can't we parallel Voltage transformer secondary circuits?
Following test should be conducted to find out relative polarity of transformenr terminals A no load test B back to back test C phasing out test D none of above
what is the write prosidure of stringing of 8meter pcc pole.
