Interested to Buy Any Domain ? << Click Here >> for more details...
If The RTD(PT100) Show .776 Kohm Resistance the Temperature of process fluid how much?
- 3 Answers
- 4524 Views
- I also Faced
- E-Mail Answers
Answer Posted / nishat
T=(R-100)/.385
R=resistance
T=temperature
put the value u will get the answer
| Is This Answer Correct ? | 10 Yes | 1 No |
Post New Answer View All Answers
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
Which type of pressure can be measured by these elements?
Boolean algebra
How to calibrate Toxic gas detector?
why we use cascade control and feed foreword control in 3 element control of boiler drum ?what is feed forward and cascade control system ?
how to turbine speed measurement?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
what is the difference between profibus and controlnet networking.
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
