Interested to Buy Any Domain ? << Click Here >> for more details...
what is the condition of transformer parallel operation ?
- 3 Answers
- 10832 Views
- BEDL, I also Faced
- E-Mail Answers
Answer Posted / medroua
Mandatory conditions:
Same phase angle shift, Same polarity, Same phase sequence and same frequency.
Convenient conditions:
Same voltage ratio & Turns Ratio, Same Percentage Impedance, Same KVA Rating, Same Position of Tap changer if any.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
our 125 kva DG does not start in AUTO mode works normally in MANUAL mode please give me a solution.....
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
Which will have more strain energy 1.Spring 2.Circular disc 3.Solid square plate.
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
Why superheated are started before I'd and rd fan?
procedure of how to generate power in solar plant.
operation
explain how the third harmonic content of the magnetising current affects transformer design
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
can u please tell me how to calculate the concrete quantity for a under reamed pile? r=300mm,depth=3m for a cylinder and for bulb l=.750mm,width=.525
why airtel use + 24 volts and other operators use -48 volt
How do you consider that you can improve and what assistance do you need to achieve this
LAPT working in alternator / generator
what is restricted earth fault explain in details
