Interested to Buy Any Domain ? << Click Here >> for more details...
Post New Answer View All Answers
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
I want to ask that is there any relation between current denesity of copper and material purity. also is ther any standard which defines the standard current denesity of material.
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
How to find out damper winding failure for synchronous machine?
draw the block diagram of fire alarm?
what is dry and wet frequency withstand voltage? why & where it is used??
Classify milling machines.
what is acceptance test in electrical engineering.
What is mean by hot and cold loop testing?
orifice sizing how done, checking & selection
If two Transformers are connected in parallel having impedance of 50KA in both transformers will the impedance increase or decrease after connecting transformers in parallel?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
what are the condition that makes hooter blow?
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
