Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between relay, contactor
- 4 Answers
- 5326 Views
- BRSS, Vishay Intertechnology, I also Faced
- E-Mail Answers
Answer Posted / sserwadda tom
A relay is suitable for switching small current and voltages where as a contactor is suitable for switching high electric current and voltages.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Why are the cores of large transformers built up of circular transactions ?
Why AC & DC capacitor are use in UPS ??????????????????
A 400KVA transformer has 400 Hz frequency. If the frequency is changed to 50 Hz, then what will be the new KVA rating?
what will be happen if earth point is being used for as a neutral point for raw power , and same will be used for ups earthing
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is meant by 3rd hormonics ?
What’s electric traction?
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
What are differences between Voltage, EMF & Potential difference ?
1)what is the function of a frequency inverter? 2)If a few frequency inverter are connected onto a device network,what are the two setting that will ensure the frequency inverter work properly on the network. 3)whats is the name of the input sensor for weigher? 4)How to confirm that the load cellis faulty? 5)Describe briefly the steps to validate that the weigher is working properly? 6)Describe the procedure to validate the flowmeter accuracy? 7)Describe briefly the steps to validate that the tempreture sensor/transformer is working properly. 8)what is the adjustment that need to be done when you are calibrating the temperature transmitter ? 9)what are the safety measures to be taken before disconnecting motor for rewinding. 10)whats is the synchronous speed in rpm of typical 4pole 50hz motor? 11)whats is the formula for kw, ohm's law 12)if a 3phase motor is rated 3kw,415vac,what is it's rated ampere?
what is a synchronizing lamp ?
What is the formula to calculate the no load current of a single & three phase induction motor
How is the gain affected by the introduction of feedback in a control system.
how to build a network which step down 415v to 1v rms
difference between main metering kiosk and check metering kiosk
