Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / karolson
Transformer bush failure causes include:
1:use of of improper conductor on termination
2:oveheating of transformer either due excessively load or failure of cooling system or internal fault.
3:loose connection on bush
4:oil spillage on bush
5:rust and moisture
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the difference between droop mode and ischnorous mode in thermal powerplant?
What is stepper motor?
Draw a 230kv two-bus bar system showing the following. 1.Two generators (150MW) each connected through one 15.75/230KV transformers 2. 1 outgoing lines 3. Two 230/130 KV transformers 4. BUS PT's 5. CT
when ac current flows thru d coil of a contactr,it energizes,magnetic field attracts d contact of the coil...nw wont dt ac current in d contct induce current back on to d coil thru mutual inductance leading to high currnt in d coil
what is effect of 5amp fuse on 2mva pry protection of transformer
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
what is p.s impedance measurement test in earthing transformer?
why incomer bay is required before transformer bay if there are more than 1 nos. of transformer bay.
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
what happens when dc generator coupled with cycle shaft.also explain what happens when its loaded
model question paper for supervisor trainee
What is the lower limit of break-down voltage of converter transformer.
What are the criteria shall be considers for sizing Fuse and MCB? If the rated current is 10Amps what should be the fuse size / MCB Size?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
