Interested to Buy Any Domain ? << Click Here >> for more details...
What is daught, what kind of draught used in boiler chimney
- 19 Answers
- 68094 Views
- Nalco, TCS, I also Faced
- E-Mail Answers
Answer Posted / pinki tandan
Draught means a force-a force required to:
a.To remove the hot gases through the system
b.Maintain a flow of air through boiler combustion chamber.
c.To supply the flue gases to the atmosphere after heating water in the boiler.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
When effect of variations in specific heats is considered then how do maximum temperature and pressure vary compared to air standard cycle ?
What are the causes of dirty lubricating oil?
How can you convert air mass to air volume?
Dear all, Will some one help me in this issue please? We are entering the Zero Stock Component in Maintenance Order, and we make a Check when the order creator is going to release system will appear Error, until he will not delete that zero stock components from the Maintenance order. but right now what the order creator is not releasing the order but he is going to save order, when's he save the order without release system will generate Reservation in the back ground, which should not happen for Zero Stock Components ? I need the way which we are doing in MB21, Reservation creation by thru Cost Center / WBS Element. At present if you run MB21 and you are going to issue the material system will not allow to generate the reservation if there are zero stock components in the list. please guide me for this issue ? Note : Simple what I need is I don't want to create any reservation thru maintenance order for the Zero Stock Components. Regards, Abdul Mujeeb
what is cyclon vibration effect in turbine
Which element causes difference in higher and lower heating values of fuel ?
One unit of btu is how many joules?
What is meant by free or natural convection?
How a main gate (steel) get support from top whlie slides on the rail fixed on the bottom surface??
Why cavitation will occur in centrifugal pump and not in displacement pump?
What are the flow characteristics?
i am preparing for vsp management trainee technical 2010.can any one send me modelpapers of preliminary written test.
I got an interview call from CANARA BANK for the post of TECHNICAL MANAGER (MMG-II), Can any one tell me what are the questions will be asked?
differentiate between total moisture and inherent moisture of coal.
what is the minimum velocity of cooling water for maximum efficiency of condensor.
