which of the following motors is non-self starting?
- 3 Answers
- 3555 Views
- SS Solutions, I also Faced
- E-Mail Answers
Answer Posted / harish
Hello guys...actually both single phase induction motor and sync motor r not self starting .capacitor is used in single phase induction motor to provide a phase shift so that it can produce a rotating electric field... Nd in sync motor interlocking with roating electric field is to be done ...which is achieved by using damper windings or by using auxiliary motor....
Thanks for reading guys...mail me at join.harishcsit@gmail.com...if u have any query... I will try to sort it out
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
How will polarity test of Dy5 Transformer ?
what is meant by skew width in machines?
How to calculate fault level of 11 KV system
CT Ratio of a energy meter connection is Red Phase : 100/5A, yello Phase : 50/5A & Blue phase : 100/5 A what is the overall Multiplication factor
What is steady state response?
I completed iti in2004 I was worked in A grade contractor can I get c licence
I have 2500KVA transformer delta/star,13.8KV/380V provided with LV 4000A breaker. Already I have 2300KW motor feeder with a full load 90%. Is it possible to connect another 1600A from that breaker? If so how the calculation is done?
what is the basic construction diffrance between servo motor ans sqiralcage induction motor
Difference between megger test equipment and contact resistance meter test instruments?
What will happen if the voltage in my house drops from 220V to any lower voltage?
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
What is the basic rule for block diagram reduction technique?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
What is nyquist contour?
