Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / mahesh
Nodes are I/O communication protocols.
Eg: DCS is the master controller, then Nodes slaves.
Nodes are normally receives data from field instruments and processes in DCS.
| Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What is the procedure of calibration of Load cell?
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
how is work pressure switch& level switch?what is the principle of this?
what is 24vdc live and dry supply
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ
WHAT IS MEANT BY PROJECT MANAGEMENT STRATEGIES IN INSTRUMENTATION?
how to relay switch sense the fault?
Basically iam Instruemntation Engineer, but Iam interested in Instruments design engineering, so plz guide, is there any course, training or Softwres to become Instrument design engineer??.
Identification of ss fittings, pilot valves, relief valve.
what are the documents(Construction point of view for a process plant) submitted by contactor initially entering in to new site for client?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
