Interested to Buy Any Domain ? << Click Here >> for more details...
hi... i'm about to learn siemens plc
i came across following question in my mind ... plr ans
1. hw motor operated by plc
2. hw drive operated by plc
explain dis by both ladder logic diagram and hardware config , connection
- 2 Answers
- 3617 Views
- KCP Cements, I also Faced
- E-Mail Answers
Answer Posted / dipesh shrivastava
All plc's work under four checks
Ai - Analog I/p
Ao- Analog o/p
Di - dig I/p
Do- Dig o/p
Commands like Motor on & Off are Do's
Commands like Drive operation, control valves operations means any type of partial operations between its low range and high range will be AO
Inputs are of 3 major types , (0-5) V DC, (0-10)v DC & (4-20) mA
All types of feedbacks like proximity ( PNP,Npn ) then feebbacks like actuator open/close, Motor on/off/trip, Feeder healthy/not healthy will be Digital inputs
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is wave length were using ?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
can we create an interrupt in plc through scada?
what is The specifications for oriface instalation
How to calibrate Magnetic flow Transmitter in Field
Which topics are covered in Process Control?
What is the use of temperature compensation?
I have 0.75mm sq multicore cable (IS type) , can use instead of same type but 1.5 sq mm cable ? Note : The distance is around about 150 meter.
How to calibration a control valve?
Difference between dcs and plc including date processing and architecture.
What is limitation of the ht.of the displacer of a level trol?
can we copy the software from a transmitter using hht(hart 275) ?
What is solenoid valve? Where it is used?
What is hp & mp seperator .& what is its working principle ?
