what do u mean by shear?and tension?
Answer Posted / arunimalr
Shear is the resisting force of a member
Tension is the elongation property of a member when a force act on it
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Method of findingthe dry ingredient quantity of 1 m3 concrete. what is the difference between static and dynamic induced emf? Testing charges bill given for Rs. 32,000/- but not added service tax in this bill. So, How much TDS will be deduct
what do you understand by M25 concrete
What is the best type of wood glue?
Why you are leaving present job?
on what basis the partial factor of safety are decided? form the load combinations
in plate load test what is the thickness of plate 20mm 5mm 50mm none
for 200 kg of cement how is the mix proportion in kg for m25 grade of concrete
When was the first motorway built in england?
Design a built-up column carrying an axial load of 1200 KN. Its length is 8m and it is effectively held in position at both ends and restrained against rotation at one end. Assume yield stress of 250 mpa
What is type failure of road surface? how to repair the failure of road surface?
1)What is the total volume of aggregates required for 1cu.mtr.solid hard concrete? 2)What is total mass of wet concrte and dry concrete after 28 days of M25? 3) Is 28 days strength is the final strength of concrete or it gets increasing as the time period increses.? 4)What is the volumetric proportion of concrete grade of M25.M30,M35,M40
in 2 way slab can additional compressive reinforcement can be provided if yes than in which conditions it is required ?
rate analysis for cement pointing 1:4 , for 100 sq m
In foundation design, while we do the base pressure check, we normally check if the attained pressure value is less than the GROSS BEARING CAPACITY of the soil which is the sum of net bearing capacity of soil and the overburden pressure. Actually, the overburden pressure acts against the net bearing capacity of the soil and I feel that we are actually increasing the bearing capacity value and doing the check. I feel that this is NOT right. Please clarify on this.
undistributed samples are obtained by