Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / vipin joshi
1.. low lube oil pressure (2.5 to 7.5 kg/cm square)
2..high coolant water temperature (95 Celsius)
3.. low coolant level 80 %
4.. overspeed (1480 to 1580)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what is the relation between size of the anteena and wavelenghth of radiated wave
PLS MENTION QUESTIONS ASKED IN IOCL INTERVIEW FOR ELECTRICAL EGG??
8. A DYNAMOMETER TYPE WATTMETER RESPONDS TO THE.......
Control wiring of a dol starter for forward and backward
What should be the amps for a MV fuses for transformer 630kVA 20(10)/0.4 kV
How stabilizer works??
What do you mean by the zone of protection?
how can we select the appropriate VCB ?
What is meant by reverse polarity and how it can be fixed?
How out of step protection relay works?
HOW TO WORK A VFD?SAY SIMPLE METHOD
What do you mean by power transformer?
Mention the disadvantages of low power factor? How can it be improved?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why we are use dol starter up to 10 hp
