Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / liza
When cutting and grinding metal. .
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
How many types of electrical earthing are there?
why the check zone and main zone are used for Busbar Protn. scheem?
why in the three pin plug all 3 pins are cutted ?
Does all the output contacts (N/O as well as N/C) of a Numerical relay operate when relay receives a binary input/inputs or contacts are designated to specific logic input/inputs and only these contacts operate?
What is the main use of rotary phase converter ?
When distance between two pulleys is not fixed, the tension of belt is adjusted by a) driver shaft b) driven shaft c) adjustment screw d) belt
why motor range is available 22kv,30kv,37kv,45kv and so on? why motor range is not available 21kv,24,25,26,27kv and so on?
what are the precuation should be taken ahen installing power transformer,circuit breaker,current & potential transformer
We have 250 KW x 2 motors, which are load from 25% to 100% varying load in every minute , so how can we compansate the power factor. pl give your opinions on the above subject.
What is the difference between shortcircuit current, rated current of cable & MCB with example? What will be the size of cable required for 5.5 KW motor (Full load current 10 Amps approx.), Starting current with DOL is 120 Amps. Aprrox. Short circuit current with LLLG fault is 2000 Amps Approx.
How would you calculate power loss in a resistor?
The 3 phase Delta connection RB=440V, BY=350V,.......* is Line to Line voltage RY= ? And Formula....?
i want to put single phase load on scott connected transformer,eventhough how to balance the transformer.
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
why the earth is taken minimum in supplying? wather it the proportional factor to getting work any equipment or a power plant?
