Interested to Buy Any Domain ? << Click Here >> for more details...
Shall we use Dyn1 transformer in place of Dyn11 for motor application as a distribution transformer
- 1 Answers
- 2885 Views
- NSL Sugars, I also Faced
- E-Mail Answers
Answer Posted / gururaj kulkarni
Dyn1 will have a phase shift of 30deg on leading side and Dyn11 will have phase shift of 30 deg on lag side. Hence the same can be used. But we can not do parallel operation as there will be dead short circuit
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
how to find the capacitance value of the motor while running??
When will you multiply and devide with derating factors to the actual value while sizing the cable?
How to measure size of cable on a given load
Define active filter?
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?
What are linear and non-linear systems?
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
How to calculate VCB rating for 33KV ,25 MW Power line?
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
I want d.g.set our company
what is v/f control in VFD?
Why can't we parallel the secondary circuits of two voltage transformers?
how pt is using
how can found motors folt current ? how can disided circuit breakers caoicity and breaking capicity ?
