Interested to Buy Any Domain ? << Click Here >> for more details...
what is suitable cable for 25 HP motor ?
start with VFD ac supply 50 hz
- 3 Answers
- 6657 Views
- Mac, I also Faced
- E-Mail Answers
Answer Posted / rafikul islam
what is suitable cable for 25 HP motor ?
start with VFD ac supply 50 hz
But i want to known, why will be cable size 16 rm, through us calculation please.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Define ampere
Why in metering Ct for ammeters ct secondary side is grounded for each Ct but not in case of CBCT (Core balance current transformer)..kindly some1 highlights the reason..is it because net flux is zero?
What is open delta Xformer? It's adavntages & Use?
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
what are the accessories need to be added while doing estimation for the following: 1.MCCB 2.MCB 3.ACB
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
sir am giving jspl exam on 19th oct . i belong to eee, so plz send previous question papers ..........to dis id abhilash203@gmail.com
What is Fire Panel ? How it works ?
how many single tension hardware are required on a double circuit transmission tower?
How could a garment factory benefit from renewable energy
hi Is there any possibilities to find out the rotation of a shaft or something else by using electromagnectic waves or by IR rays.If s then can v change the dir., of rotation of the same by remotely?& how? plz dn't any1 say "NO r CAN'T"
Why we use circular(Stepped) cross section in transformer core?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
can I improve the furnace power factor (10 mva transformer) by adding a capacitor bank before the transformer.Does system power factor vary a lot with the furnace PF?
