Answer Posted / ram singh yadav

A Zener barrier is an associated equipment that is installed in the safe area. It is designed to limit the amount of energy that could appear in an electrical circuit passes through the hazardous area despite the connection before the barrier.

A barrier consists of:

1. Resistors to limit the current

2. Zener diodes to limit the voltage

3. Fuses to protect the components

How to calibrate Toxic gas detector?

1764

---

Hi,can anyone help me out with PhD programs related to Instrumentation field?I have a degree in electronic Instrumentation?

1978

---

which type inter lock use in petrochemical refinery,and oil & gas?

3067

---

How to Calibrate Ultrasonic flow Transmitter in Field

1315

---

What are the charcterstics of a P&ID controller block for Governor speed raise or lower for a load sharing functionality between 4 Gas turbines in droop mode.

3073

---

what is the field bus calble ? what are diffrences in orang colur cable and black coular calble ?

3091

---

How to decrease opening & closing time of on/off valve?

1549

---

What is zero elevation and zero suppression?

2233

---

With N nodes and B branches what will have a network ???

2075

---

Why rdt and thermocouple both give different output .and one things more, how to generate  ohm or mili volt  plz mail me merajalam143545@yahoo.com

2849

---

can we copy the software from a transmitter using hht(hart 275) ?

2126

---

what is the procedure to callibrate temp controller ,pressure controller,etc. suppose a temp controller showing error 1.5 degree centigrate how can i minimize it.

2384

---

How does temperature bath work? How does coil gets heated only by applying some current?

1870

---

IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?

2447

---

typical loop drawing of a simple feedback control comprising of one transmitter and one control

2041

---