Interested to Buy Any Domain ? << Click Here >> for more details...
how to select the cables based on amps ratings ?
how to calculate the amps and how to select the cable size
- 1 Answers
- 2841 Views
- JV Electricals, I also Faced
- E-Mail Answers
Answer Posted / muhammed
first you calculat the load after that you calculate the current using this equation I= P/(ROOT3*V*POWER FACTOR)
after there is one cable selection table(available in google) using current rating check that cable and select the cable size
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why moisture formation found in XLPE Armoured cable outer sheath
What is called limb of a transformer?
Can RCD's used to protect the VVVF drive if not why.
Differenciate between circuit wiring and sub main wiring with illustrations
a)In a 3-phase 4-wire circuit, a circuit breaker is selected to protect the circuit whose highest fault level is 6.6 MVA. Determine the required minimum breaking capacity in kA. (Note: Covert 3-phase power in terms of kA to find answer.) b)Using the below, determine the required minimum making capacity in kA as a “peak value”. Rate breaking capacity (Icn) ka: Icn<= 1.5 Factor = 1.41 1.5
what is mean by parallel operation of permanent magnet generators
wHAT IS CAPACITANCE LATCHING? hOW TO CALCULATE CAPACITANCE LATCHING? hOW TO SOLVE THE PROBLEM IF CAPACITANCE LATCHING APPLIED?
what is earth pit , how we can measured it, what earth rods reference
I Want randstand placement papers
Write down the name of 2 lady Bir Pratin of Bangladesh
will 1050kva DG set withstand for back charge of 16MVA transformer
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
What is the power factor of a transformer at no load?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What is gain margin?
