Interested to Buy Any Domain ? << Click Here >> for more details...
What is the correct position of lapping splice of reinforcement steel bars in a beam at top & bottom of the beam?? what is the reason for this location?..what are the factors affecting lapping location in beam?
- 6 Answers
- 19005 Views
- SPCL, I also Faced
- E-Mail Answers
Answer Posted / maqsood
In simply supported beam lapping is not permissible.
In continuous beam
Top bars can be lap at L/3
Bottom bars can be lap before or after V.Support
| Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
What is the difference between Rock And Murrum. How to claim that excavated material is not a murrum but rock.
how to calculate the strength of rebound hammer test reading in building construction ?
how gradation of aggregates effect on slump of fresh concrete?
Describe the sections included in a typical bill of quantities
What is the bowing depth after stressing of PSC Girder of various spans and various dia of strands?
Explain major differences between routing maintenance and major maintenance.
What is Time period of a building and its relation with frequency ?
The internal dimensions of a wire house 15m*5.6m and the maximum height of piles is 2.70m. What is the maximum number of bags to be stored in two piles ?
What is Density of cement, sand & aggregate ?
Draw the cross section of a boundary wall and label its part with detailing?
How to calculate density of 40 mm coarse aggregate, in mixing ration 1:1.5:3? Please explain calculation for density
What is the use of water table & Kreb stone for drain
Is there any course for billing available in Mumbai? If yes then please mail me the details..
whou haat goals do you have in your career
