Interested to Buy Any Domain ? << Click Here >> for more details...
what are the components of a start and stop motor control?
- 2 Answers
- 4251 Views
- I also Faced
- E-Mail Answers
Answer Posted / mohd azharuddin
It depends on type of starting methods u r opting, for example u can use DOL METHOD which requires one overload protection relay, one contactor, two push buttons, one nc and one no elements but the disadvantage of this method is high inrush current so this method shoudnt be used for big motors
Another method is STAR DELTA METHOD in which u require one overload protection, three contactors, one for main, second for star, third for delta, one timer with relay logic, two push buttons, one no and nc elements, in this method motor is started in star connection for the first few seconds and then changeover to delta, by using this method we can reduce high inrush current.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
what type of questions are asked and howmwny questions belong this catagory?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
how can tell us the AC indoor or outdoor which Tr and formulls
What will happen if we introduce negative feedback to a control system that uses a positive feedback?
What are the reasons for the parallel operation of transformers?
Pls mail me utility & Dg related question with answer
What does quality factor depend on in resonance?
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
What are the parameters of water ( Water quality )to be monitored in Centralised HVAC ( water cooler chillers )
What is icu and ics in Acb and how many time icu or ics passes from breaker?
what's the requirement of Dy11d0 connection of 3 phase transformer?what's use of it?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
does a DG set has low fault level as compared to that of a transformer.If yes then why.
