Interested to Buy Any Domain ? << Click Here >> for more details...
What is the correct position of lapping splice of reinforcement steel bars in a beam at top & bottom of the beam?? what is the reason for this location?..what are the factors affecting lapping location in beam?
- 6 Answers
- 18748 Views
- SPCL, I also Faced
- E-Mail Answers
Answer Posted / rahul sharma
In beams:
In Top bars, lap should be comes under the portion of L/2 (Regular Zone) and not more than 50% of can be lapped a single point so lap should be alternate. And the min. distance b/w two alternate lap must be spaced by LD from the center to center of lap.
In bottom bars laps come under the portion of L/2. Where L is clear length of the beam.
| Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
what is mean by c32/40s concrete class
For Wet Mix Mecadam design what is Optimum moisture content
What out turn civil works
how to disign cuplock shuttering and it's matireal requirement snd any related web site
minimum number of bars in a beam? minimum and maximum column size and beam size ? minimum and maximum aggregate size used in multistorey residential building for columns,beams,slabs?
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
How can you achieve soil enforcement?
What is unit weight of roadway layer.. 1.bitumen 2.sand 3.soil 4.concrete 5. aggregate give me some reference for this answers
how we check the thickness and line of ceiling plaster.
For The preparation of goverment examination Which book i will prefer and by which way i will do the preparation for exam.
How to cal. The weight of hollow pipe?
The foundations are placed below ground level, to increase?
What are the important hardware systems used for cad?
What is structural frames or systems?
List out some of the common problems that architect have to tackle it?
