Interested to Buy Any Domain ? << Click Here >> for more details...
Why is starter necessary for a three-phase induction motor?
- 37 Answers
- 180381 Views
- BMM, Essar, Hero MotoCorp, ITI, Maruti Suzuki, Supertech, Watt, I also Faced
- E-Mail Answers
Answer Posted / dhaval
1) The rotor of the three phase induction motor is act as a short circuit secondary while the stator winding is act as a primary winding of transformer.
2) Due to this, short circuited secondary, the current flowing through primary winding increases upto its 5 to 7 times the rated current for a few seconds.
3) Due to the increase in current, I2R losses are takes place in stator winding which results in overheating.
4) Similarly, it also reduces supply voltage at the time of starting.
5) Hence, in order to avoid this problems, starter is necessity for starting of induction motor.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
which network topology offers the greatest level of tolerance?
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
Differentiate between low pass, high pass and band pass filter?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
why burdens of VTs is more than CTs?
i have total 8 dg sets for synchronizing and 2 buscoupler,1 sectoin dg no 1,2,3,and 2 sectoin dg no 4,5,6,and last section dg no 7,8 ....if buscupler no 1 and 2 is off mode ..than dg no 1,2,3,will synchroniz of another dg sets?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
Transformer diagram mention each parts ?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
plz explain the auot-reclosing circuit in electrical engineeing
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
WHAT IS IM (INDEX OF MOUNTING )IN MOTORS
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
Do Phase angle measurement have any application in freq/harmonics measurement? If so how?
