Answer Posted / saif rizvi
1 mtr or 3.28 feet or 39 inches
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Bitumen grades are 30-40,60-70, 80-100. what is mean by 30- 40
What is binding spacing of the rebars at lapping zones.
How to calculate concret slab? W l t(4mts*5*2fts) ratio m25 grade pls tell me procedure
what is the painting co efficient of slope roof tiles?
Define What happens to Load at yielding ?
What are some structures that may be subjected to fatigue?
std penetration resistance in very stiff clays lies bet 2 & 4 4 & 8 8 & 15 15 & 30
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 600 microns?
i want to ecil (Electronics Corporation of India Limited Hyderabad) previous civil engineering question papers immediately please.............
How to check slab shuttering level.? Or check list for slab ?
pls tell me about method of cutting length of ties column
Currently my house construction is going on but we just realized that the portico earth beam couldn't connect with the original earth because the beam rod not extended so Please advice
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
What are the reasons for geotechnical site investigations in uganda?
natucher of concrete &type of concrete?
