Interested to Buy Any Domain ? << Click Here >> for more details...
Less cost of delta connection over star connection
a. No fourth neautral wire
- 1 Answers
- 2298 Views
- I also Faced
- E-Mail Answers
Answer Posted / nitesh singh
Yes because in delta connection neutral wire is not required.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What are the specifications for getting approval of Substation?
Why star delta starter is preferred with induction motor?
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
should %impedance be high or low in a power transformer? if so why?
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
What happens to a motor if it is connected in Delta connection
How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?
trasnfarmaer core make
what is mean by parallel operation of permanent magnet generators
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
how does a shunt reactor maintains the bus voltage???
What is vaccum currcuit breaker.define with cause and where be use it device?
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
I have two PLC processors. I want to communicate both processor with each other. How i can do so?
what is the calculation formula for motor starting torque,running torque, running torque.
