Question 34 – In the distillation of binary systems by Mc Cabe Thiele method, the equation for the line of top section is given by y = [ R / (R + 1) ] x + XD / (R + 1). 2 points on the line are (0.99, 0.99) and (0, 0.36). Find the reflux ratio of R and XD.
- 1 Answers
- 1835 Views
- I also Faced
- E-Mail Answers
Answer Posted / kang chuen tat (malaysia - pen
Answer 34 : The slope is given by R / (R + 1) = (0.99 - 0.36) / 0.99 = 0.6363. Rearranging the equation gives R = 0.6363 / (1 - 0.6363) = 1.7495. Choose the point (0, 0.36) as reference, 0.36 = XD / (R + 1), XD = 0.36 (R + 1) = 0.36 (1.7495 + 1) = 0.9898. The answer is given by Kang Chuen Tat; PO Box 6263, Dandenong, Victoria VIC 3175, Australia; SMS +61405421706; chuentat@hotmail.com; http://kangchuentat.wordpress.com.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
I HAVE DOMAIN KNOWLEDGE IN PROCESS MANUFACTURINGAND I GOT AN APPARTUNITY AS A BUSINESS ANALYST AND I DNT HAVE ANY KNOWLEDGE ON ORACLE APPS/GIVE ME ANY VALUBLE SUGGESTION?
Define pcbs?
Explain can large temperature differences in vaporizers cause operational problems?
What is the practical particle size limit for pneumatic conveying?
What are some good estimates for heat transfer coefficients for coils in tanks?
Explain the strategies acquired to cure tube vibration and exchangers in a shell?
Are there any general rules that should be considered when designing a slurry piping system?
What is the order of a chemical reaction, , if the rate of formation of 'C', increases by a factor of 2.82 on doubling the concentration of 'A' and increases by a factor of 9 on trebling the concentration of 'B'?
MY generator water cooler inlet line height - 11 mtr inlet water line height - 7 mtr water come into the line from overhead tank, O/H tank height - 20 mtr the first tapping in the inlet line is 2" line which down to 4 mtr level plateform., second tapping in inlet water line goes to a pump 6" line installed at 4 mtr level plateform, pump capacity 200m3/hr, head- 30 mtr, hp-40. the outlet of pump of 6" water line connected to a header of 6 mtr long of 6" line, on this header the six tapping are connected, 4 nos. 3" line goes to 11 mtr height water cooler the pressure of the line is 0.15 to 0.25 kg/cm2, 2" and 4" pipe line connected to a cooler at 4 mtrlevel plateform. my question is, at 11 mtr height level the quantity of water and flow is not sufficient for my cooler, the temp. of cooler is rises much more. you are requested to suggest the modification of pipe line/ pump for take more water flow and pressure (desired pressure is 1 kg/cm2)
Name some common causes of control valve noise?
How can you separate hydrogen peroxide into hydrogen and oxygen?
What are some typical applications for glass-lined reactors?
What type of heat exchangers are most commonly used for a large-scale plant-cooling loop using seawater as the utility?
What type of pump may be appropriate for a liquid near saturation, a low flow rate, and very limited npsha (net positive suction head available)?
At what temperature does water have maximum density?
