Answer Posted / hammad akhtar
If v apply force on any object,tension force varies outwards to the object.....
And on the other hand,compression force varies inwards to the object.....
Dt's it....
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Would you cause a 55-gallon drum of water to weigh more by climbing in?
how gradation of aggregates effect on slump of fresh concrete?
What is OSHA compliance?
Which percentage of carpet area use in plot area of office building.
natucher of concrete &type of concrete?
What are the applications of the modulus of elasticity?
Minimum concrete cover in slabs, columns, beams, foundation and other st?
What is the frequency of sampling for the materials of cement,Fine aggregate, Coarse aggregate .and refer which code
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
Where is the worlds longest elevator and how long is it?
WHAT IS THE MAIN DIFFERENCE B/W HIGHWAYS AND MOTERWAYS?
how to do sudoko puzaals?
how to workable concrete cube test M-25 design mix
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
What are the different softwares used for cad?