Interested to Buy Any Domain ? << Click Here >> for more details...
why need 3 element system in power plant?
if it is not there then what l happen?
- 5 Answers
- 12544 Views
- I also Faced
- E-Mail Answers
Answer Posted / kmns kiran
Three element control is just for better controlability of drum level with feed water incoming flow, steam output flow & drum level
In case of any bad signal from feed water & steam flow (BDQ) , then control will go to single element drum level control.
Plant will not trip
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
To become an Instrument DESIGN engineer, is there any softwares or training to become Instrument Design engineer, plz suggest me, Iam very much interested in designing.
how to calculate range of level transmitter?
If we increase only P what will be controller action ?
in mass flow meter what is drive friquancy ?
What are different types of control valves?
How oil line flow measured?eplain about instruments used and working principle?
Which is the best field foundation bus. ( FF ) Yokogawa, Honeywell or others ?
how to work MIL contol valve posistioner ?
how works encoder in plc
what is the input of digital counter during the the calibration time?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.
Any body have know try work calculation ???
HI, can anybody give details about GAS TREATMENT PLANT CONSTRUCTION,as INSTRUMENTATION ENGINEER what are the responsibilites.what are the instruments mainly instrumentation engineer will deal with
what is dc moter.
