Answer Posted / sangram kumar sahu
power protection instrument distribution board
Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
pls someone send me sample question papers along with the key.thanks in advance
what is the working principle of energy saver control panel. please give the complete calculation & theory.
What is mean by Sensitive Earth fault & what are the effects
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
how to check regenerative load in drived motor
What are the basic elements used for modeling mechanical rotational system?
WHY NUTRAL GROUND SYSTEM USED IN 33KV SYSTEM
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
In a Impedance Based Distance Relay (Quad Characteristics) - Could there be two different Line Angle(RCA) for Ph-Ph & Ph-Gnd? If So Kindly Let me Know.. Where, What are the advantages of the same?
how to calculate distance between busbar supporters for LT panel, what are the factors influencing in this design
can we install HT panel & LT panel side by side or how much clearance is required ?
Explain cos(theta) and Sin(theta)
impliment (AB)`+C to transistor representation
Refernce currents are to be generated using refernce cueernts how can this be done
how to determine the cable size...pls explain me with the formula taking particular load....does the factors like impedance & short circuit rating influence the cable size, if so how....