Interested to Buy Any Domain ? << Click Here >> for more details...
where connected OLTC for transformers?
- 3 Answers
- 7494 Views
- Apollo, CBRE, I also Faced
- E-Mail Answers
Answer Posted / sandip dobariya
it is connected on HV side of TRF because low current at HV side
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
how to make an earthing certificate
can i use 2000/5A Clamp meter to measure HT cable
What is signal flow graph?
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
In AC if the direction of current keeps reversing every half cycle, how does it propogate through the transmission lines?
how the B-H loop obtain under the static condition
what is the ground fault relay,which purpose it will be use,clearly tell me plz
What is kirchoff ’s current law (kcl)?
What are PLC leader logic program method
What is fault clearing time for Current Limiting Moulded Case Circuit Breaker?.
how much GROUND & NEUTRAL VOLT maintain in data center.
in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.
WHAT IS THE WINDING PROCEDURE OF ELECTRICAL MOTOR
what is the voltage regulation for unity and zero power factor?
