Interested to Buy Any Domain ? << Click Here >> for more details...
what is meant by motor protection relay & its working
principle ?k
- 1 Answers
- 4583 Views
- Pricol, I also Faced
- E-Mail Answers
Answer Posted / vinoth
its for Protecting motor in overload,earthfault,underload and single phasing.
it need CT inputs / Some of the relay will works without CT by direct insert the power cable in Power-hole of relay.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
Brief working principle of stabilizer,application & safety precautions
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
How will change the frequency in distribution side?
How to calculate earth fault current for 6.6 KV , 50 HZ , 756 Amps , 3000 RPM , 0.8 PF generator
What is ideal IR values for ground and neutral.
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
how you taken aotitude test
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
What do you mean by Frame 5 Gas Turbine as well as Mark II.
What do you mean by transformation ratio of instrument transformer?
Does outdoor isolator loose connection cause short circuit current in that circuit? if yes then how ??
I am having a 42KW 3 phase electrical heating furnace, heating element is 80/20 nichrome material, my connections is made in such a way that 2 star connection compromising 2 coils per phase so totally 12 coils, shall if i use it unbalanced star condition (instead of 2 group of 3 phase or 1 group of 3 phase, connecting 4 phases of 5 phases) what will be the consequences and is it acceptable?
