Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / poras patel
Desired strength : S1
Achieved Strength : S2
Percentage Strength = S2/S1 x 100
if S1= 40 N/mm2
S2= 20
% strength = 20/40 X 100
= 50
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
what is the use of steel rods of 16mm or 20mm used for 4.45mts for closing gutter.one mate consumes how many kgs with a gap of 6inches.
Define polar co ordinates.
what will happen if one could not properly follow the spacing of slab reinforcement bar?
plumbing CPVC fitting FTE Brass full form
What is gravity flow?
what will be the cost of thickness of 125mmor rcc measurement of 52x33.75 feet
Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No. Loading Axial force Moment Shear 1 DL+LL 1950 600 20 2 Seismic load 250 4800 700
how much shouid be the rate for ready mix concrete per cubic meter
What is hybrid foundation?
Which stone is best for wall construction Laterite Stone or Cement Blocks
What is the outturn of Ceiling plastering
Which are the Steel tests ?
what is the sequence of the activities in the typical under ground water tank including civil & MEP works.
In reclamation works what are the importance of geotextiles and sand?
What is the requirement for over all CG of DG from the foundation surface to absorb the vibration of heavy set.
