Answer Posted / kaushik chowdhary

M10= 1:3:6
M15= 1:2:4
M20= 1:1.5:3
M25= 1:1:2
.
Mix Design from M30 onwards

5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)

2186

---

How to Rectify deep crack formed on Brick Wall? Explain the method of rectify the defect?

8062

---

Which type of plywood & sizes using in construction projects ?

1111

---

how many numbers of 4inch bricks and get consumed in 9 inch BB masonary wall in cubic feet.plz send my below e.mail adress

1897

---

what are the proper pipes for salt water line

2400

---

What is c.g.i sheet which used for roof??

1986

---

How do you measure water flowing through 300mm diameter pipes?

1172

---

What are the responsibilities of a construction manager?

1356

---

I was once rejected for US visa in early August. But now I'm going again for interview next week. What are the chances that I will faced the same VO????

2327

---

how to calculate cost of raw materials of a building for 1000 sqft & also consolidated cost of labour in a 1000 sqft building

2911

---

60-70 grade of Bitumen is VG-30 ?

2178

---

How to calculate concrete in percentage wise ,for example cement 18% sand 40% aggregate 40% and Stell 2% ,I need and??

2158

---

Required amount of Steel bars, cement/ square feet for roofing of residential building upto 3rd floor.

1836

---

Explain what is the difference between built area and super built up area?

1248

---

How to calculate chejja reinforcement

2615

---