Answer Posted / saran
because of ionisation with sorrondingb conductors
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Is there any guideline say about display of earthing value near to earth pit
Is Transol transformer oil comparable to nynas nytro libra?
why we need to us lenz's law for synchornous motor
A 7 storey building has a floor area of 35,000sq.ft on each storey. On the ground floor 11KV electrical sub-station is to be erected. A load of 3kw for every 400sq.ft (p.f is 0.8) is proposed for each floor. fire pump 7.5hp, water pump 5hp, lift 2 nos, each 10hp and 20shop load of each shop is 5kw. calculate a. load each floor b. total load of building c. L.T feeders for aech floor and from transformer to main. d. distribution diagram e. capacity of sub-station/capacitor bank f. line diagram
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
It is desired to flood light the front of a building 42 meters wide and 16 meters hig.Projectors of 30 degree beam spread and 1000 watt lamps giving 20 lumen/watt are availabl.If the desired level of illumination is 75 lumen/m and show a suitable scheme.Assume the cofficient of utilization, deprecitation factor and waste light factor are 0.4, 13 and 1.2 respectively.
How much inductance or resistance require as a starter in series with induction motor of specific capacity(e.g. 5 hp) ? What is formula for it ?
how to compute kvar in substation feeder to improve power factor and sending voltage
What are the parts in a inverter?
Can anybody tell abt concrete encased earthing or grounding?
Is there any Institution for giving M-tech in Electrical engineering for those who r in service? Give the details please.
why wire sizes are 3/29 or 7/29 and why not wire sizes are 2/29 or 6/29?
send me any model test paper of clerical post of state bank of india.......
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain