How can get electrical "c" licence.I am complited in
Deee.Passing year of 1993.Working in pvt cocern lt
Line.Please advise me .Cell no 9994786021
Answer Posted / selvakumar.k
2014 b.E eee batch,i have worked in industries 500 kva transformer,2 years experienced in maintenance dept,then how to get c license ,kindly tell me sir,mob no:8754801506
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what is the pulse and audio frequency transformer? what is different between induction regulators and tap changing transformer?
how can i reduce sparking without stepdowning the voltage
why we use copper earthing for neutral while for body GI.
What is expention fastener (Fan)
The capacitive reactance of a capacitor of 1/(2(PI)) F at 10^3 H is
Starting Time of LT & HT Motor
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
WHY EXCITER PHASE SEQUENCE ARE OPPOSITE THAN STATOR SUPPLY PHASE SEQUENCE IN SYNCHRONOUS MOTOR >
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Why you are switching off arc protection mcb when you are taking shutdown for lv board.
what is mean by Digital Logic Meter (DLM)
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
what is difference between elr and R eartl realy.
what is the purpose that we use PLC system in power system
Define pole pitch?