Interested to Buy Any Domain ? << Click Here >> for more details...
In my home i am getting too much electricity bill (more than 4000) but I am very much sure that we are not consuming that much. How i can check this ?
- 6 Answers
- 6187 Views
- I also Faced
- E-Mail Answers
Answer Posted / akaram
Your old meter pic upload on olx. And sell it then purchase new meter from flipkart. Try this
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
why impedance relay is used for medium transmission line protection
number of I/O devices in siemense plc
What is the difference between a verilog task and a verilog function?
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
What are the special cables required for explosion proof wiring?
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
why do motors burn out? I understand why adding parallel loads to a power source means more current moves through the circuit, and can destroy circuit elements by overheating. What about when you have a vaccuum cleaner intake flush against a floor, a room fan sitting directly against a wall, or a power drill trying to drill through something too hard?
what is the transiant condition in alternator? and how it can be prevanted?
What is DTR erection?
What is meant by reset level of the relay?
List examples of current sources?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
how to build a network which step down 415v to 1v rms
why +24 v and -48 v give to BTS? If -48v protect from surge then why we not use -24 v?
