In a dc series motor increases in lord current results in
- 4 Answers
- 2651 Views
- I also Faced
- E-Mail Answers
Answer Posted / subrat sahu
Speed of the motor decreases and torque increases...
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Explain how to determine capacitor tolerance codes?
why we used ZNO in Lightning arrester.
What is the different between conventional MCC and intelligent MCC? Common controller or controller for each bucket
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
how to fit 3 HP crompton gear motor with conveyor with the use of staring delta starter or ordinary starter?
What Is Connection APFC Panel In Compony.
What will be the current if the resistance total in a series circuit doubles?
why impedance relay is used for medium transmission line protection
Define phase lag and phase lead?
i need to now what will be the cable size to the following load, transformer to distribution panel distance 110m, load 1000kw, voltage 400v, pf 0.85, permissible voltage drop 2.0%, overhead line, atmospheric temperature 35 degree c.
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
what is the responsibility of C license holder in industry?
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
Which do you think is the most significant cause of energy loss in a factory?
