Answer Posted / raja
Simply span and zero adjustments
| Is This Answer Correct ? | 1 Yes | 7 No |
Post New Answer View All Answers
Explain Gas Turbine startup and shutdown sequences
Draw block digram for well head from well to shipping pump?
How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?
What is the constant voltage unit?
any body who gone thru recent iocl interview.INSTRUMENTATION questions. I need.
how to change measuring units from mmwc to cubm/h in rosemount air flow transmitter with hart communicator fluke 744
Hi i m B.E. In elect. & comm. I m workin in bio mass plant from 6 mnths as inst. Engg. but now i m in dept. Of operation as shift engg...which is best operation or inst. 4 me? M confusd..plz help and reply me..
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
How to calibration coriolis flow meter?
how to calibrate and troubleshooting of leveltroll?
i am preparing for BARC ,so plz mail me how to prepare for BARC. ALSO IF POSIBLE SOME RELATED QUESTIONS. MY MAIL ID IS khushi_4uall2003@yahoo.co.in
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
Who to difference between analog in & analog out in dcs?
Emergency Shutdown Systems/ Plant Shutdown System.
what would be the minimum flow rate that we can measure on rotameter..?
