Interested to Buy Any Domain ? << Click Here >> for more details...
Where we can use 3.5c cables instead of 4c cables.Why?
- 4 Answers
- 13952 Views
- I also Faced
- E-Mail Answers
Answer Posted / sourabh vishwakarma
from 3.5c cable we can save cost instead of using 4c cable.in 3.5c cable .5c is using only for neutral for completing path.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Battery is a voltage source? give one example of current source and why?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What is the reason of polyphase induction motor tripping suddenly on high current during running at 70% laod? Motor IR , winding resistance & inductance balance. Motor no load current is balance and ok as per mgfr. data.
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
electrical knowelge
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
kindly send me 11KV MV motor differential protection procedure by primary injection method.
Why only sinusoidal ac voltages are generated?why not triangular or sawtooth?
quantizer means?
how is find out kwh step by step
How do you compute voltage drop and cable size over distance?
what is the IS foe lightning arrester?
How npn and pnp transistor works
Thermal withstand capability under full short circuit conditions, in terms of number of times of occurrence of short circuit and corresponding anticipated percentage reduction in transformer life.
When we use air circuit breaker, it has O/L protection ,time delay SC protection, Instataneous SC protection & ground fault protection. They all have some setting range. But what is the suitable/allowable setting for the above protection which will be safe for the equipment? For example-O/L protection setting have a range of (0.4,0.45,0.5,0.55,0.6,0.65,0.7,0.8,0.9,1.0)xIn Time delay SC protection have a range of (1.25,1.5,2,3,4,6,8,10,12)xIn Time delay setting is 0.02,0.1,0.2,0.3,0.4 Instataneous setting is fixed to 20xIn Gound fault setting is given 100A,300A,600A,900A,1200A This setting are for 2500A ACB. So what will be the basic allowable setting for the above protection? is there any formulae to calculate this<
