Interested to Buy Any Domain ? << Click Here >> for more details...
how we can to the synchronization in transformer. What are the
conditions for that.
- 1 Answers
- 4718 Views
- I also Faced
- E-Mail Answers
Answer Posted / alokverma
1-) polarity should be same
2) per unit impendence should be same
3)resistance/reatance ration shuold be same
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to protect sensitive loads such as Dosing pumps inside a factory from voltage surge/voltage fluctuation.
Hi, My plant daily consumption is calculated as 3.8MWH but my supplier has sanctioned an power of 2.6MW per day. how can i equal or distinguish this two factors
What is Auto Mains Failure Panel & Auto Synchronizing Panel
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
how does ELR works? explain
what is the acceptable value of TAN DELTA and dissipation factor for 11kV, 1.75HP Motor?.
Why we specify TNC switch with 1NO 1NC ,2NO 2NC ? how we get connection.?
How to calculate energy stored in an inductance?
which are the criterias needed to select the kind of neutral earthing(solid earthing,resistance earthing,etc.) at various voltage levels in electrical distribution?
What is reactive power and where it is used.
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
fuel-air ratio in a petrol engine fitted with suction carburettor,operating with dirty air filter as compared to clean filter will be
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
Why earthing is necessary for any equipment?
Why we use mho Relay in long transmission line?
