Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / harishdarade563
The power factor is the ratio of the real power that is used to do work and the apparent power that is supplied to the circuit. Power factor values are between 0 to 1.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
whit is 33kv power 300*300 cable full current with formula
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
In a large office how do we calculate required number of light fittings, assuming fittings are 4x18W or 2x36W fluorescent fitting ?
Draw torque - speed curve and load curve of induction motor? mark operating point ?
What is shunt voltage and u v voltage witch one best
could anybody able 2 send me jindal steels previous papers fr electrical steam....pls send 2 my id if possible....sirisha.shaik@gmail.com
why are u join ntpc
Why cables and busbar both needed in LT Panels?
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
In Dyn11 power transformer if any one of the 3 phases connected to earth in star connected side then please explain effect of the current flow in delta connected side of transformer.(In this case if one phase is shorted to ground in star connected side then we observe the current flow in two phases only not three phases in delta connected primary side. Please explain why it is so?)
What is non-minimum phase transfer function?
Draw the circuit of clapp oscillator?
How to calculate or formula to calculate rhe power in 2 phase system ??
What does a Bode plot tell you?
where the lexical paramater will use in fron end?
